Single-cylinder circular socks machine is a socks machi […]
Single-cylinder circular socks machine is a socks machine for knitting long, medium and short socks and pantyhose with a single cylinder.
It can produce socks with various organizations such as flat needles, yarn adding, loops, jacquards, loops, and stripes. The main loop forming parts are tongue needle, sinker, foot piece and jacquard piece. Tongue needles are divided into long, middle, and short. Generally, the long and short needles are respectively arranged on the half circumference of the barrel. The tongue needle moves up and down in the cylinder groove to knit. The sinker is located between the tongue pins for radial entry and exit, and its role is to hold the coil when retracting the loop and pull the coil after the loop is formed. The length of the coil is determined by the distance of the needle from the plane above the sinker when forming a loop. The foot piece can transfer the movement to the tongue needle, and the jacquard piece has multi-stage piece teeth, which can be used for needle selection. After the needle is selected, the tongue needle runs in different routes.
To decide whether to participate in weaving.三角 The upper and middle triangles and the left and right yarn bending triangles of the circular socks machine triangle system are symmetrical triangle seats, so the needle can be knitted in one or two directions. The jacquard triangle acts on the tab of the jacquard piece, which can make the tongue needle rise to the height of the backing loop, pass over the right-curved triangle, press down the upper and middle triangles, feed the yarn, and then descend along the left-curved triangle. New coil, take off the old coil, and then rise along the panel to form a coil. If the jacquard piece is pushed into the groove of the cylinder by the needle selection mechanism, it will not rise along the triangle of the jacquard, and the tongue needle will run at a lower position.