How to repair the glove machine


At present, the glove machine appearing on the market i […]

At present, the glove machine appearing on the market is a modern type of knitting machine for textile gloves. Generally, various kinds of half-finger, full-finger gloves, five-toed socks, and labor protection gloves can be produced according to needs. Many grown-ups should know that the machine will malfunction after a long period of use. In order to improve the efficiency of the machine, it is necessary to understand the troubleshooting methods of the glove machine. Let's take a look at a few simple problem repair methods.
1, striker
The firing needle is a kind of failure that often occurs in the knitting machinery. Although laymen rarely hear about it, it will have an important impact on the use of the machine. Therefore, the firing needle should be avoided during use. Knitted gloves are now used in our lives very much, and the glove knitting machines that produce it are even more used by manufacturers. In the course of this glove knitting, it often happens that the knitting needle of the knitting needle and each knitting triangle collide with each other and cause a mechanical failure. This is what we call a firing needle. For such a failure, the glove knitting machine is easily damaged, so it has been resolved immediately, so as to avoid excessive mechanical damage. Therefore, manufacturers of glove knitting machines must always inspect and repair the machine or know the solutions to the fault of the striker, so as to avoid the emergence of the striker.
2, break the upper looper thread
Many cotton gloves manufacturers will encounter the fault that the upper looper thread is often broken. There are two main reasons for this failure. One is that the stitches are wrong or the pressure on the lower looper clamp plate is too high. Failure should pay attention to the security threading or loosening some clamp nut on the upper looper thread. The second reason is that the eye of the upper loop needle is out. If it is caused by this reason, you should use a string to apply polishing paste and put it into the upper loop of the needle. Or simply change the looper.